Postprocessor Mach 3 Drilling Problem 
Postprocessor Mach 3 Drilling Problem 
May 16 2011, 08:11 AM
Post
#1


Newbie Group: Members Posts: 3 Joined: 14May 11 Member No.: 3,258 
I am using Sprutcam 2007 and Mach3 and I have the following problem.
Sprutcam detect a hole pattern, generate the corresponding toolpath and the simulation is working fine in Sprutcam. With this code all holes except the first one will be drilled twice.......!!!!!!!! The postprocessor generator generate the following code: % OPlattePlexi N0001 G90 G17 G40 G80 G49 (HOLE MACHINING) N0002 M998 N0003 T133 G43 H133 M6 (1MM DRILL) N0005 G0 X485.0000 Y245.0000 Z1.2000 S6500 M3 N0006 G81 Z3.1 R0.2 F2000 M8 N0007 X480.0000 N0008 Z3.1 R0.2 N0009 X475.0000 N0010 Z3.1 R0.2 N0011 X470.0000 N0012 Z3.1 R0.2 N0013 X465.0000 N0014 Z3.1 R0.2 N0015 X460.0000 N0016 Z3.1 R0.2 N0017 X455.0000 N0018 Z3.1 R0.2 N0019 X450.0000 N0020 Z3.1 R0.2 N0021 X445.0000 N0022 Z3.1 R0.2 N0023 X440.0000 etc. My question is: can I instruct the postprocessor to make only one hole. Or have anybody out there a working MACH3 postprocessor ? I put my postprocessor, as an attachment..... Thanks
Attached File(s)



LoFi Version  Time is now: 24th March 2019  11:13 PM 