Printable Version of Topic

Click here to view this topic in its original format

SprutCAM forum _ SprutCAM 10 _ second operation on a part

Posted by: Art K Nov 19 2017, 10:29 PM

I am trying to machine a flange. My intent is to drill the three holes in one operation, then mount it on a fixture from two of the drilled holes and use an end mill to do the ID hole and outside contour. This is probably a basic question but, how do I use the part from the previous operation (with the holes) as the part in the second operation. The first will be in the vise, the second will be held in a fixture by 4-40 shcs.
Art K

Posted by: Sprut_UK Nov 23 2017, 01:59 PM

This tutorial is for an earlier version of SprutCAM, but it should still be fairly relevant:


Posted by: Art K Dec 5 2017, 03:12 AM

 New_exhaust_flange_holes.stc ( 272.27K ) : 2
Sprut-UK,
Sorry I missed your reply. I watched the video but failed to see the relevance. I have since went ahead and drilled the holes in the exhaust mounting flange, two #43/.089 holes and one .375 in the center of the part. When I made this part previously I ignored the fact it was already drilled and while machining the hole from .375 to .437 and let it work its way from the center out. I know It should recognize work done in a previous operation but cant figure it out. Here is the file I'm working on. I can figure out how to set up the machining profiles, but not how to get it to recognize part done in a previous operation. I also have recognized a reoccurring theme that if I don't know the exact terminology to search for I cant hind anything.
Art

Posted by: Sprut_UK Dec 7 2017, 08:27 AM

Hi Art, thank you for the clarification of your question. I have created this short video that I hope answers your question? Attached is the updated version of your SprutCAM 10 project.



Dave

 New_exhaust_flange_hole_dps.stc ( 243.61K ) : 0
 

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)