anafranil online

Welcome Guest ( Log In | Register )

Reply to this topicStart new topic
> Postprocessor for Denford Easiturn lathe
Rick Turner
post Apr 27 2011, 04:57 PM
Post #1


Group: Members
Posts: 7
Joined: 18-February 11
Member No.: 3,214


the attached file is a post-processor that generates g-code for a Denford Easiturn3 lathe running under mach3.

This should work with any XZ lathe that works in radius mode with X as the radial axis - there is nothing 'special' in the code.

A couple of people asked me for this earlier and I sent it offline; if you have that earlier version replace it with this one (2.1) as I've fixed a problem with arcs that showed up under some conditions.

Regards to all,

Attached File(s)
Attached File ( 6.06K ) Number of downloads: 8
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


Lo-Fi Version Time is now: 16th July 2019 - 10:21 PM