Printable Version of Topic

Click here to view this topic in its original format

SprutCAM forum _ SprutCAM Postprocessors _ Postprocessor for Denford Easiturn lathe

Posted by: Rick Turner Apr 27 2011, 04:57 PM

All:

the attached file is a post-processor that generates g-code for a Denford Easiturn3 lathe running under mach3.

This should work with any XZ lathe that works in radius mode with X as the radial axis - there is nothing 'special' in the code.

A couple of people asked me for this earlier and I sent it offline; if you have that earlier version replace it with this one (2.1) as I've fixed a problem with arcs that showed up under some conditions.

Regards to all,

Rick

 DenfordXZ2.1.zip ( 6.06K ) : 8
 

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)