anafranil online
IPB

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> Imperial Fanuc Post Tip
MickeyD
post Jun 18 2008, 02:36 PM
Post #1


Advanced Member
***

Group: Members
Posts: 33
Joined: 14-December 07
From: Austin, TX
Member No.: 2,289



I have run into a problem off and on where cutting a G02 or or a G03 circular interpolation would cause the machine to halt on a 020 error (radius out of tolerance error) when in inch/imperial mode. To fix this, go into your post editor and increase the number of digits following the decimal point from 3 to 4 for x, y, z, i, and J and then save the modified post as something like Fanuc_Imperial. You will still have your original metric post but also have an imperial. Works like a champ after that.
Go to the top of the page
 
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: 15th July 2019 - 09:00 PM