anafranil online

Welcome Guest ( Log In | Register )

Reply to this topicStart new topic
> Haas 5D for UMC 750, not issuing G254/G255 every time it is needed
post May 21 2018, 04:49 PM
Post #1


Group: Members
Posts: 22
Joined: 12-December 07
From: Romania
Member No.: 40


I am using a Haas 5D for UMC 750 post-processor.

When making 3+1 and 3+2 indexed operations, it is necessary to use G254 (activate dynamic work offset DWO) / G255 (deactivate DWO).

G254 is needed before moving the rotary axes (B and C) and has to be deactivated with G255.

When a new orientation of the part is needed, G254 and G255 have to be used again.

The SprutCAM post-processor generates G254/G255 only for some operations, even the orientation of the workpiece is changed.

Did anyone run into same problem ?

I have attached a project file, the post-processor and the code generated by SprutCAM and the code generated by another CAM solution (which is correct).

Attached File(s)
Attached File ( 249.55K ) Number of downloads: 1
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


Lo-Fi Version Time is now: 16th July 2019 - 12:38 AM