anafranil online
IPB

Welcome Guest ( Log In | Register )

> 3D/2D contouring question
bll230
post Jul 16 2016, 10:23 PM
Post #1


Member
**

Group: Members
Posts: 20
Joined: 20-September 13
Member No.: 3,558



Dave, Trying to learn about the 3D contouring, which I admit I do not understand because the manual doesn't say anything about the top and bottom offset fields,
I made this simple test piece.

I have a 2D contouring with project toolpath and a 3D contouring that I have been playing with individually by swapping their order in the list.

If you look at the verify compare it shows that the 2D contouring cuts the exact amount at the highest z level but leaves too much material as it moves to the lowest z level.

The 3D is the opposite. It cuts the proper amount at the highest z level, but then cuts too much as it moves to the lowest z level.

Nothing I have tried will make it cut the proper amount all the way around the bevel and consequently show green all the way around in the verify compare.

A quick lesson on the 3D contouring would be helpful as the online English manual gives no information specific to the 3D that is not also about the 2D.

Thanks

John
Attached File(s)
Attached File  Bevelpractice.stc ( 249.24K ) Number of downloads: 3
 
Go to the top of the page
 
+Quote Post
 
Start new topic
Replies
Sprut_UK
post Oct 18 2016, 04:59 PM
Post #2


Advanced Member
***

Group: Administrators
Posts: 1,091
Joined: 12-December 07
From: United Kingdom
Member No.: 4



The 3D Contouring (3D Curve) operation has been there in every version of SprutCAM that I have used.

I don't use the 3D Contouring operation very much. 3D Contouring allows you to use 3D curves / edges whereas 2D Contouring only allows the use of 2D curves. Making a quick comparison, 2D Contouring includes 'T slot level' and 'Helical' options which aren't there in 3D Contouring.
As far as I am aware, 3D Contouring doesn't have any 5 axis capabilities.

I hope this helps?

Dave





--------------------
"Never interrupt your opponent when he is making a mistake..." - Napoleon Bonaparte
www.sprut.co.uk
Go to the top of the page
 
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: 24th February 2019 - 05:10 AM