anafranil online

Welcome Guest ( Log In | Register )

Reply to this topicStart new topic
> tool holder question
post Mar 27 2015, 09:08 PM
Post #1


Group: Members
Posts: 20
Joined: 20-September 13
Member No.: 3,558

This isn't earth shattering, but I cannot figure it out.

I have the Tormach tool holders defined with inch measurements, but the tool in the picture with the holder seems to me to be in mm, since it is so outsize. The built in holders with mm definitions would seem to bear this out.

I have the tool catalog units set to inches, and the overall setup set to inches.

The toolholders display properly in the tool page of each operation, so my program is working fine, I just can't figureout how to get the tool catalog picture to display right.

Picture one is the unit setting in the tool catalog.

Picture 2 is the odd one with my Tormach holder.

Picture 3 is a built in holder.

Picture 4 is the system setup page.

Picture 5 is how it displays in an operation.

Any thoughts on how to readjust the endmill size in the holder picture?


Attached File(s)
Attached File  example1.JPG ( 44.27K ) Number of downloads: 7
Attached File  example3.JPG ( 61.35K ) Number of downloads: 18
Attached File  example2.JPG ( 70.46K ) Number of downloads: 11
Attached File  example4.JPG ( 55.85K ) Number of downloads: 10
Attached File  example5.JPG ( 112.86K ) Number of downloads: 6
Go to the top of the page
+Quote Post
post Mar 28 2015, 09:36 AM
Post #2

Advanced Member

Group: Administrators
Posts: 1,091
Joined: 12-December 07
From: United Kingdom
Member No.: 4

Hi John,

I rarely use imperial units so I can only suggest setting SprutCAM to metric units while you set the tools?


"Never interrupt your opponent when he is making a mistake..." - Napoleon Bonaparte
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


Lo-Fi Version Time is now: 18th July 2019 - 10:51 AM